HP mc-Series 5042 Rack Options Installation Guide

Automatic Door Release Kit 15
o
To install the strike plate in the full lock position, align the strike plate assembly directly to the strike
plate bracket, inserting the flathead screw into the third hole from the top of the strike plate bracket.
Use the Allen wrench to attach the strike plate assembly to the strike plate bracket by tightening the
flathead screw.
o To install the strike plate in the half lock position, align the strike plate assembly to approximately
3/4 of the strike plate bracket, inserting the flathead screw into the fourth hole from the top of the
strike plate bracket. Use the Allen wrench to attach the strike plate assembly to the strike plate
bracket by tightening the flathead screw.
Installing the front door release spring
1. Align the U-loop release spring with the holes in the spacer block.
2. Using a T-25 Torx screwdriver, insert and tighten two M5 x 10mm pan head screws into each hole in
the spacer block.
3. Align the spring on the block with the two holes on the door.