HP mc-Series 5042 Rack Options Installation Guide

Hook Up Kit 32
Callout Component Function
hose—Outlet
B
Main water hose—Inlet Brings cold water into the MCS 5042
4. Use a pipe wrench to tighten the hose connections an additional two flats.
Attaching the main hoses to the MCS 5042 above the
floor
1. Using a T-30 Torx screwdriver, remove the two screws securing the bottom rear panel to the unit. Save
the screws.
2. Re-use the screws to install the rear plate with the cutout facing the unit.
3. Route the main hose through the opening in the rear plate into the MCS 5042.
4. Run the flexible hoses up, and connect them to the 90° elbow assembly.
5. Hand-tighten the hoses to the 90° elbow assembly.