HP mc-Series 5042 Rack Options Installation Guide

Hook Up Kit 33
6.
Using a pipe wrench, tighten the hose connections an additional two flats.
Attaching the main hoses to the MCS 5042 through
the top of the unit
1. Using a T-30 Torx screwdriver, remove the four screws securing the top panel to the unit. Save the
screws.
2. Re-use the screws to install the top plate with the cutout facing the unit.
3. Route the main hose through the opening in the top plate into the MCS 5042.
4. Run the hoses down, and connect them to the 90° elbow assembly.
5. Hand-tighten the hoses to the 90° elbow assembly.
6. Using the pipe wrench, tighten the hose connections an additional two flats.