HP Modular Cooling System Generation 2 site preparation guide - Technical white paper

32
Chilled water system components
The chilled water supply and return service for each HP MCS G2 are required to have a particular
combination of components for peak performance. These components are identified in figure 25 and
described in table 7.
Figure 25: Recommended plumbing configuration for the HP MCS G2
The 1-micron filter may require a minimum clearance of 762 mm (30 inches) under the floor for installation. If the filters cannot
be installed under the floor due to space constraints, they may be located further upstream in the piping system.
Note:
Components in figure 25 drawn with a solid line are strongly
recommended. Components drawn with dotted lines are advisable for a
higher safety standard.