Replacement Instructions for the Condensation Pump and Sensors HP Modular Cooling System

Removing the air deflector
plate
1. Loosen the two thumbscrews securing the air deflector
plate to the MCS unit.
2. Disconnect the green and yellow ground bonding wire.
3. Lift the air deflector plate up, tilt it to an angle, and pull it
out toward you.
To replace this component, see "Replacing the air deflector
plate (on page 5)."
Removing the condensation
pump and sensors
1. Disconnect the AC power cable from the condensation
pump.
2. Disconnect the two sensor connections from the
condensation pump.
3. Loosen the thumbscrew on the bottom of the
condensation pump securing the condensation pump to
the MCS unit (1), and lift the condensation pump from
the MCS unit (2).
To replace the component, see "Replacing the condensation
pump and sensors."