Replacement Instructions for the Condensation Pump and Sensors HP Modular Cooling System

Replacing the condensation
pump and sensors
1. Align the condensation pump thumbscrew to the hole
inside the MCS unit (1), and tighten the thumbscrew on
the bottom of the condensation pump to secure it to the
MCS unit (2).
2. Connect the two sensor connectors to the condensation
pump.
3. Connect the AC power cable to the condensation pump.
Replacing the air deflector
plate
1. Reattach the ground bonding wires to the air deflector
plate.
2. Align the two screw holes on the air deflector plate to the
two screw holes inside the MCS unit.
3. Secure the air deflector plate to the MCS unit by
tightening the two thumbscrews in the two screw holes.
Relocating the power inlet box
back into position
1. Lower the right side of the power inlet box until it is back
into the horizontal position.
2. Push the power inlet box back into the MCS unit until it
locks in place.
3. Replace the outer support bracket.