Replacement Instructions for the Heat Exchanger Unit HP Modular Cooling System

1. Insert the new heat exchanger unit into the same position
as the heat exchanger unit you removed.
IMPORTANT: Keep the Torx screws separated
according to their thread type and note which
thread type came from which hole location on the
shipping bracket.
2. Install the two heat exchanger unit shipping brackets.
a. Align the heat exchanger unit shipping brackets to
the screw holes on the heat exchanger unit and the
MCS frame (1).
b. Using a T-25 Torx driver, secure the two heat
exchanger unit shipping brackets to the heat
exchanger unit by inserting and tightening four
Torx screws (2).
c. Using a T-25 Torx driver, secure the two shipping
brackets to the MCS frame by inserting and
tightening four Torx screws (3).
3. Open the rear MCS door.
4. Connect the green and yellow ground bonding wire to
the heat exchanger unit.