Replacement Instructions for the Magnetic Solenoid Valve HP Modular Cooling System

Powering down the MCS unit
1. Open the front MCS door.
2. Turn off the AC1 and AC2 breakers on the AC transfer
switch.
3. Open the rear MCS door.
WARNING: To reduce the risk of electric shock or
damage to the equipment:
• Do not disable the power cord grounding plug.
The grounding plug is an important safety
feature.
• Plug the power cord into a grounded (earthed)
electrical outlet that is easily accessible at all
times.
• Unplug the power cord from the power supply to
disconnect power to the equipment.
• Do not route the power cord where it can be
walked on or pinched by items placed against it.
Pay particular attention to the plug, electrical
outlet, and the point where the cord extends from
the storage system.
4. Disconnect the two AC power cables from the power
connectors, labeled Primary and Secondary, on the
power inlet box.
5. Disconnect the network cable from the RJ-45 connector
on the power inlet box.
Required tools
To complete the following steps, you will need:
• T-25 Torx driver
• Phillips screwdriver
To complete the following steps, you might also need:
• Water hose fitting wrench (included with your original
MCS unit)
• Counter hold wrench (included with your original
MCS unit)
Removing the bottom fan unit
1. Open the rear MCS door.
2. Using a T-25 Torx driver, remove the four Torx screws
securing the horizontal shipping bracket to the MCS
frame.
3. Loosen the two thumbscrews on the bottom of the
fan unit.
CAUTION: The fan unit wei
g
hs 16.8 k
g
(37 lb). Use
extra caution when removing and replacing the top
fan unit because it might be higher than your
shoulders and is heavy and awkward to lift.