Replacement Instructions for the Magnetic Solenoid Valve HP Modular Cooling System

Lift the air deflector plate up, tilt it to an angle, and pull it

out toward you.

To replace this component, see "Replacing the air deflector

plate (on page 5)."

Removing the magnetic

solenoid valve

1. Adjust the water hoses connected to the rear of the

bottom heat exchanger unit and hold them out of the

way to reach the magnetic solenoid on the valve. This

process can be difficult. If you struggle excessively,

disconnect the In and Out water hoses on the back of the

bottom heat exchanger unit using the counter hold

wrench and the water hose fitting wrench.

2. On the magnetic solenoid valve, release the silver

retainer tab (1), and remove the magnetic solenoid from

the valve post (2).

3. Using a Phillips screwdriver, remove the Phillips screw

securing the electrical connector to the magnetic

solenoid.

To replace the component, see "Replacing the magnetic

solenoid valve (on page 4)."

Replacing the magnetic

solenoid valve

1. Using a Phillips screwdriver, connect the electrical

connector from the MCS unit to the magnetic solenoid by

inserting and tightening one Phillips screw.

2. Adjust the water hoses connected to the rear of the

bottom heat exchanger unit and hold them out of the

way to reach the solenoid valve post. This process can

be difficult. If you struggle excessively, disconnect the In

and Out water hoses connected to the bottom heat

exchanger unit using the counter hold wrench and the

water hose fitting wrench.