Replacement Instructions for the Magnetic Solenoid Valve HP Modular Cooling System

Place the magnetic solenoid back on the valve post (1),

and press down until the silver retainer tab locks the

magnetic solenoid in place on the valve (2).

Replacing the air deflector

plate

1. Reattach the ground bonding wires to the air

deflector plate.

2. Align the two screw holes on the air deflector plate to the

two screw holes inside the MCS unit.

3. Secure the air deflector plate to the MCS unit by

tightening the two thumbscrews in the two screw holes.

Relocating the power inlet box

back into position

1. Lower the right side of the power inlet box until it is back

into the horizontal position.

2. Push the power inlet box back into the MCS unit until it

locks in place.

3. Replace the outer support bracket.

a. Lift the right side of the bracket up at a slant, and

slide the bracket into the MCS unit.

b. Tighten the four thumbscrews to secure the outer

bracket to the MCS unit.