Replacement Instructions for the Operator Display HP Modular Cooling System

7. Squeeze the four release tabs on the top and bottom
of the operator display (1), and push the operator display
from the back to the front through the front
MCS door (2).
NOTE: Cables are removed for clarity.
8. Remove the display button by squeezing the two release tabs
on the sides of the display button (1) and pushing the
display button from the back to the front through the front
MCS door (2).
To replace this component, see "Replacing the operator display (on
page 3)."
Replacing the operator display
1. Hold the four release tabs while pushing the operator display
from the front to the back through the front
MCS door.
2. Hold the two release tabs while pushing the display button
from the front to the back through the front
MCS door.
3. Push the cable down through the cable management hose (1),
and connect it to the management module connector (2).