Replacement Instructions for the Water Temperature Sensor HP Modular Cooling System

2.
Slide the bottom fan unit inside the MCS unit on the
sliding rails.
3. Tighten the two thumbscrews to secure the fan unit to the
MCS frame.
4. Using a T-25 Torx driver, secure the horizontal shipping
bracket to the MCS unit by inserting four Torx screws.
Replacing the AC transfer
switch
1. Connect the green and yellow ground bonding wires to
the water group controller.
2. Connect the electrical power cables from the MCS unit to
the AC transfer switch.
a. Connect the three small cables, starting from the
right and moving to the left, by pressing the tab on
the bottom of each cable and pushing it into the
connector.