Replacement Instructions for the Water Temperature Sensor HP Modular Cooling System

b.
Disconnect the X13 cable connector if you are
repairing the outlet water temperature sensor.
To replace this component, see "Replacing the water
temperature sensor."
Replacing the water
temperature sensor
1. Insert the new water temperature sensor probe into the
appropriate water line.
2. Place the cap nut over the water temperature sensor.
3. Using two 18-mm wrenches, tighten the cap nut over the
water temperature sensor.
4. Route the water temperature sensor cable through to the
front of the MCS unit.
5. Connect the water temperature sensor cable connector
to the water group controller connector labeled either
X12 or X13.