Replacement Instructions for the Water Temperature Sensor HP Modular Cooling System

Replacing the condensation
pump and sensors
1. Align the condensation pump thumbscrew to the hole
inside the MCS unit (1), and tighten the thumbscrew on
the bottom of the condensation pump to secure it to the
MCS unit (2).
2. Connect the two sensor connectors to the condensation
pump.
3. Connect the AC power cable to the condensation pump.
Replacing the air deflector
plate
1. Reattach the ground bonding wires to the air
deflector plate.
2. Align the two screw holes on the air deflector plate to the
two screw holes inside the MCS unit.
3. Secure the air deflector plate to the MCS unit by
tightening the two thumbscrews in the two screw holes.
Replacing the air sealing plate
1. Slide the air sealing plate into the MCS unit.