HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type
Module
typeLog messageID
A TCP retry for a frame failed on the
connection ddbIndex. TPB contains
the frame memory address.
ErroriSCSI#%d: ql_process_error:
OB_TCP_IOCB_RSP_W returned DdbInx 0x%x
pTpb %p
75008
Restart iSCSI processor.InfoiSCSI#%d: QLDisable: Restart RISC86347
EEPROM updated, restart iSCSI
processor.
InfoiSCSI#%d: QLEnable: Restart RISC to update
EEPROM
86349
Link up reported by iSCSI processor
for GE1 or GE 2.
InfoiSCSI#%d: QLIsrDecodeMailbox: Link up86874
iSCSI controller reported a link
speed/configuration of 100 Mb
full-duplex FDX.
InfoiSCSI#%d: QLGetFwStateCallback: link 100Mb
FDX
87346
iSCSI controller reported a link
speed/configuration of 1000 Mb
FDX.
InfoiSCSI#%d: QLGetFwStateCallback: link 1000Mb
FDX
87348
iSCSI controller reported an invalid
link speed.
InfoiSCSI#%d: QLGetFwStateCallback: Invalid
link speed 0x%x
87350
FC1 processor SRAM test failed.FatalFC#%d: qlutm_init: Diagnostic failed,
port 1 invalid SRAM
102419
FC1 POST failed.FatalFC#%d: qlutm_init: Diagnostic failed,
port 1 POST failed
102420
FC2 processor SRAM test failed.FatalFC#%d: qlutm_init: Diagnostic failed,
port 2 invalid SRAM
102421
FC2 processor POST failed.FatalFC#%d: qlutm_init: Diagnostic failed,
port 2 POST failed
102422
Fibre Channel processor failed to
return diagnostic results.
FatalFC#%d: qlutm_init: Failed to return
diagnostic result to Bridge
102423
Fibre Channel processor failed reset.FatalFC#%d: QLInitializeAdapter: Reset ISP
failed
102656
Fibre Channel processor firmware
load failed.
FatalFC#%d: QLInitializeAdapter: Load RISC
code failed
102657
Fibre Channel processor receive
sequencer code load failed.
FatalFC#%d: QLInitializeAdapter: Load ISP2322
receive sequencer code failed
102658
Fibre Channel processor transmit
sequencer code load failed.
FatalFC#%d: QLInitializeAdapter: Load ISP2322
transmit sequencer code failed
102659
Fibre Channel processor firmware
checksum failed.
FatalFC#%d: QLInitializeAdapter: Verify
Checksum command failed (%x)
102662
Fibre Channel processor firmware
initialization failed.
FatalFC102680 #%d: QLInitializeFW: FAILED102680
Fibre Channel processor paused due
to internal parity error.
FatalFC#%d: QLInterruptServiceRoutine: Risc
pause %x with parity error hccr %x,
Disable adapter
102688
Fibre Channel processor returned an
invalid interrupt status.
FatalFC#%d: QLInterruptServiceRoutine:
Invalid interrupt status: %x
102689
Fibre Channel processor system
error.
FatalFC#%d: QLIsrEventHandler: System error
event (%x), MB1=%x, MB2=%x, MB3=%x,
MB4=%x, MB5=%x, MB6=%x, MB7=%x
102716
128 Log messages