HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type
Module
typeLog messageID
Response queue entry contains an
invalid handle.
FatalFC#%d: QLProcessResponseQueue: Invalid
handle %x, type %x
102746
Fibre Channel processor external
SRAM parity error count exceeded
limit; Fibre Channel port disabled.
FatalFC#%d: QLTimer: Ext Ram parity error
exceed limit cnt 0x%x, limit 0x%x,
Disabled adapter
102752
Fibre Channel processor heartbeat
failed.
FatalFC#%d: QLTimer: Heartbeat failed102755
Fibre Channel processor being
restarted.
FatalFC#%d: QLRestartRisc: restart RISC102800
Fibre Channel processor received a
SCSI command for an unknown
ErrorFC#%d: QLUtmReceiveIo: Path invalid/FW
No resource count %x
106583
target path or has run out of
resources to issue additional
commands.
Fibre Channel processor was
disabled by an IOCTL request to the
driver.
ErrorFC#%d: QLIoctlEnable: Adapter disabled106589
Fibre Channel processor firmware
failed initialization. The request to
ErrorFC#%d: QLIoctlEnable: Initialize FW
error
106590
initialize was received by the driver
in an IOCTL request.
Fibre Channel processor failed the
external loopback test.
ErrorFC#%d: QLIoctlRunDiag: Diagnostic
loopback command failed %x % %x %x
106592
Fibre Channel processor failed to
re-initialize in response to an IOCTL
disable request.
ErrorFC#%d: QLIoctlDisable: Re-initialize
adapter failed
106593
Fibre Channel processor reported a
link down condition.
ErrorFC#%d: QLIsrEventHandler: Link down (%x)106803
Fibre Channel processor reported an
unexpected asynchronous event. The
ErrorFC#%d: QLIsrEventHandler: Unexpected
async event (%x), MB1=%x, MB2=%x,
MB3=%x, MB4=%x, MB5=%x, MB6=%x, MB7=%x
106813
mailbox registers provide status,
event code, and data related to the
event.
Fibre Channel controller reported an
invalid Entry Status %x, type %x.
ErrorFC#%d: QLProcessResponseQueue: Invalid
EntryStatus %x, type %x
106847
Fibre Channel controller failed to
provide a heartbeat.
ErrorFC#%d: QLTimer: Heartbeat failed106851
Driver has determined that the Fibre
Channel link is unreliable and
ErrorFC#%d: QLTimer: Link error count (0x%x)
exceeded, link down
106853
unusable due to the number of errors
encountered. The link has been taken
down.
Fibre Channel processor was unable
to obtain the number of loop IDs
ErrorFC#%d: QLReserveLoopId: out of loop Ids106912
required. This failure occurs only
when the Fibre Channel processor is
running multi-ID firmware.
Driver was unable to re-establish
connection to the target within the
ErrorFC#%d: QLMarkDeviceOffline: Device Id:
%x marked offline, cLinkDownTimeout =
%x, cPortDownRetryCount=%x
106928
timeout and retry counts, and is
therefore marking it offline.
129