HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type
Module
typeLog messageID
Fibre Channel processor is unable to
log into the Fibre Channel fabric
name server.
ErrorFC#%d: QLSnsGetAllNext: Name server
login FAILED %x
106948
Driver’s host (initiator) database is
full.
ErrorFC#%d: QLUpdateDeviceData: out of slots
in host database
107029
Driver’s target database is full.ErrorFC#%d: QLUpdateDeviceData: out of slots
in target database
107030
Driver’s host (initiator) database is
full. Maximum host database is 64.
ErrorFC#%d: QLUpdateDeviceDatabase 0x%x:
GET_ID failed %x
107041
Drivers host (initiator) database is full.ErrorFC#%d: QLUpdateDeviceDatabase 0x%x: out
of slots in host database
107056
Driver was unable to re-establish
connection to the target within the
ErrorFC#%d: QLUpdatePort 0x%x: out of slots
in host database
107078
timeout and retry counts, and is
therefore marking it offline.
Fibre Channel controller failed a
Flash write (address x data x).
ErrorFC#%d: QLWriteFlashDword: Write fails at
addr 0x%x data 0x%x
107984
Fibre Channel controller failed the
Get VP Database command (for
virtual port %d).
ErrorFC#%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for VP %d
fatal error
108032
Fibre Channel controller failed the
Get VP Database command (for
virtual port %d) with status x.
ErrorFC#%d: QLGetVpDatabase:
MBOX_CMD_GET_VP_DATABASE for VP %d
failed %x
108033
Fibre Channel controller reported
failure status for an Execute IOCB
command.
ErrorFC#%d: QLVerifyMenloFw:
EXECUTE_COMMAND_IOCB failed MB0 %x MB1
%x
108049
Fibre Channel controller reported a
fatal error while processing an
Execute IOCB command.
ErrorFC#%d: QLVerifyMenloFw:
EXECUTE_COMMAND_IOCB fatal error
108050
Fibre Channel controller reported
failure status for a Get Firmware
State command.
ErrorFC#%d: QLGetFwState: Get Firmware State
failed 0-3 %x %x %x %x
108064
Request to reset the Fibre Channel
processor (adapter) received from
IOCTL interface.
InfoFC#%d: QLIoctlDisable: Reset adapter118882
Fibre Channel LIP occurred. The LIP
type is reported, as is the contents of
InfoFC#%d: QLIsrEventHandler: LIP occurred
(%x): mailbox1 = %x
119088
the Fibre Channel processor’s
mailbox 1 register.
Fibre Channel LIP reset occurred. The
LIP reset type is reported, as is the
InfoFC#%d: QLIsrEventHandler: LIP reset
occurred (%x): mailbox1 = %x
119089
contents of the Fibre Channel
processor’s mailbox 1 register.
Fibre Channel link up occurred. Event
status is reported, as is the contents
InfoFC#%d: QLIsrEventHandler: Link up (%x)
mailbox1 = %x
119090
of the Fibre Channel processor’s
mailbox 1 register.
Fibre Channel link up occurred. Event
status is reported, as is the
InfoFC#%d: QLIsrEventHandler: Link mode up
(%x): RunTimeMode=%x
119092
130 Log messages