HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type
Module
typeLog messageID
Router configuration has changed.InfoUserqapisetbridgebasicinfo_1_svc:Bridge
configuration changed
151897
GE port %d was enabled user.InfoUserGE%d: Port status changed by user to
ENABLED.
151908
GE port %d was disabled by user.InfoUserGE%d: Port status changed by user to
DISABLED.
151909
Fibre Channel port %d was enabled
by user.
InfoUserFC%d: Port status changed by user to
ENABLED.
151910
Fibre Channel port %d was disabled
by user.
InfoUserFC%d: Port status changed by user to
DISABLED.
151911
Target at WWPN:
xx.xx.xx.xx.xx.xx.xx.xx has been
mapped to iSCSI portal %d.
InfoUserqapimaptargetdevice_1_svc: Target
WWPN: %.2x%.2x%.2x%.2x%.2x%.2x%.2x%.2x
mapped to iSCSI portal %d.
151912
Target at WWPN:
xx.xx.xx.xx.xx.xx.xx.xx has been
unmapped from iSCSI portal %d
InfoUserqapimaptargetdevice_1_svc: Target
WWPN: %.2x%.2x%.2x%.2x%.2x%.2x%.2x%.2x
unmapped from iSCSI portal %d.
151913
FCIP route #n has been successfully
added.
InfoAppFcipRoute#%d Added152069
FCIP route #n has been successfully
modified.
InfoAppFcipRoute#%d Modified152070
FCIP route #n has been successfully
removed.
InfoAppFcipRoute#%d Removed152071
An Initiator's configuration has
changed.
InfoUserqapiaddmodifyinitiator_1_svc :
Initiator Configuration Changed
152082
An Initiator has been removed.InfoUserqapiremoveinitiator_1_svc : Initiator
Removed
152083
A set array was performed on one
of the arrays.
InfoUserqapisetmigrfctargets_1_svc:
Configuration Changed for migration
target
152096
Encountered an error while updating
the migration log entry. Some
InfoUserLogMigration: Error in Writting log
file
152099
migration log entries might be
missing.
Group with ID specified in the log
was added.
InfoUserqapiaddgroup_1_svc: Added Group with
id %d
152100
Group with ID specified in the log
was removed.
InfoUserqapiremovegroup_1_svc: Removed Group
with id %d
152101
Group with ID specified in the log
was updated.
InfoUserqapiupdategroup_1_svc: Updated Group
with id %d
152102
Serial schedule jobs scheduled to
start at time specified in the log.
InfoUserqapisetserialjobs_1_svc: Serial Time
%lu
152103
Readjust priority command completed
with an error. Error code 2 indicates
InfoUserqapireadjustpriority_1_svc: Readjust
Priority Failed on line %d with error
%d
152104
no scheduled jobs were found. Error
code 16 indicates a job with priority
1 was configured.
134 Log messages