HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type
Module
typeLog messageID
The TCP link for FCIP route #n has
disconnected. The MAC or Ethernet
ErrorFCIPFcipRoute#%d: TCP Link Down, MAC
Stats: Tx Dropped Count=%ld Rx Dropped
172303
statistics include total packet dropped
Count=%ld Tx Pause Count=%ld Rx Pause
Count=%ld
during transmit (TxDropped), total
packet dropped during receive
(RxDropped), total Ethernet pause
frames transmitted (TxPause), and
total Ethernet pause frames received
(RxPause).
The total number of TCP
retransmissions that occurred in the
ErrorFCIPFcipRoute#%d: Tcp Retranmissions in
last 10 Sec %d, OutStanding
Completions %d FC Frames
172304
last ten seconds before the link was
brought down due to a keepalive
timeout. It also displays the total
number of outstanding transmissions
that were pending to be transmitted
through the GbE port.
The FCIP route #n went down
because the Fibre Channel port on
the remote peer went down.
ErrorFCIPFcipRoute#%d: FC link on the remote
peer went down
172322
TCP link for FCIP route #n has been
established.
InfoFCIPFcipRoute#%d: TCP Link Up184515
FCIP link is up for FCIP route #n.InfoFCIPFcipRoute#%d: FCIP Link Up184536
FCIP route #n: Incorrect VLAN
configuration.
ErrorFCIPFcipRoute#%d: VLAN Info Unavailable184542
Ethernet port was not able to
negotiate the configured speed.
ErrorNICQL3xxx:%s: Auto Negotiation error
detected
205571
Ethernet port speed is not supported.ErrorNICQL3xxx:eth%d: Unsupported speed
portConfig 0x%x
205572
Ethernet device could not be
configured.
ErrorNICQL3xxx:ql3xxx_probe: cannot allocate
ethernet device %s
206080
The Ethernet port was not able to
register as a network device resulting
ErrorNICQL3xxx:ql3xxx_probe: cannot register
network device %s
206089
in a port initialization error for the
specified network device.
The total number of TCP checksum
errors detected on the Ethernet link
belonging to the eth#%d port.
ErrorNICQL3xxx:eth%d: TCP/IP checksum error -
TotalChecksumErrorCount = %lu
206114
Ethernet port is operating at 100
mbps speed.
InfoNICQL3xxx:%s: PHY Downshift occurred217856
Ethernet link is up.InfoNICQL3xxx:%s: Link Up217857
Ethernet link is down.InfoNICQL3xxx:%s: Link Down217858
Ethernet port is down.InfoNICQL3xxx:%s Adapter Down218389
Ethernet port is up.InfoNICQL3xxx:%s Adapter Up218401
Uncorrectable memory error detected
at address provided in log message.
FatalSystem"memory monitor: Detected
Uncorrectable Ecc %08lx system is
rebooting in 5 secs\n"
233473
Attempt to register the interrupt
handler failed.
FatalSystem"Failed to register interrupt
handler!\n"
233474
137