HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)
MPX200 <1> (admin) #> exit
MPX200 #>
fcip route
Configures a new FCIP route and lets you modify or delete an existing FCIP route.
Each FCIP route requires a dedicated Fibre Channel and Gigabit Ethernet port. Configuring an
FCIP route and specifying a Fibre Channel and GE port pair takes precedence over any previously
existing configuration for the port pair (FC/GE), and removes the existing configuration of the port
pair.
Authority
Admin session
Syntax
fciproute {add | mod | rm}
Keywords
add configures a new FCIP route.
mod modifies an existing FCIP route.
rm removes an existing FCIP route.
Notes
You can also configure an FCIP route over a 10 Gb Ethernet port, provided that the router has
both an available 10 Gb port and the FCIP 10 Gb license installed. The same FCIP commands
(fciproute add, fciproute mod, and fciproute rm, as well as show fciproutes)
can be used to configure, remove, and view the FCIP route through a 10 Gb Ethernet port. See
the example in the following.
Examples
MPX200 <1> (admin) #> fciproute add
A list of attributes with formatting and current values will follow. Enter a
new value or simply press the ENTER key to accept the current value. If you
wish to terminate this process before reaching the end of the list press 'q' or
'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both GE ports.
Configuring FCIP Route:
-----------------------
FCIP Interfaces FC & GE (0=Enable, 1=Disable) [Enabled ]
FC Port (1=FC1 2=FC2) [ ] 1
GE Port (1=GE1 2=GE2) [ ] 1
IP Address (IPv4 or IPv6; 0=IPv6 Link Local) [0.0.0.0 ] 172.35.15.11
Subnet Mask [0.0.0.0 ] 255.255.254.0
Gateway IP Address [0.0.0.0 ] 172.35.14.1
Remote IP Address [0.0.0.0 ] 172.17.136.18
MTU Size (0=Normal, 1=Jumbo, 2=Other) [Normal ]
TCP Window Size (0=32KB, 1=64KB, 2=128KB,
3=256KB, 4=512KB, 5=1MB, 6=2MB,
7=4MB, 8=8MB, 9=16MB) [32768 ]
Window Scaling (0=Enable, 1=Disable) [Enabled ]
Window Scaling Factor (Min=0, Max=9) [7 ]
TCP Port No. (Min=1024, Max=65535) [3225 ]
GE Port Speed (0=Auto, 1=100Mb, 2=1Gb) [Auto ]
Bandwidth, Mbit/sec (Min=1, Max=1000) [1000 ]
VLAN (0=Enable, 1=Disable) [Disabled]
fcip route 15