HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

• Data Migration
• SAN over WAN
Authority
None
Syntax
help
Examples
This section provides examples of each help command set. The help command differs for the chassis
and the blade. The following example shows the help command for the chassis:
MPX200 #> help
admin {begin | end | start | stop | cancel}
blade {1 | 2}
exit
help
history
logout
quit
reset [factory | mappings]
show [chassis]
The following example shows the help command for the blade:
NOTE: The show presented_initiators command shown in the help output is not supported
in this release.
MPX200 <1> #> help
General Command Set:
======================
General Command Set:
======================
admin {begin | end | start | stop | cancel}
beacon {on | off}
get_target_diagnostics
clear {logs | stats | portstats}
clear logs
clear stats
clear portstats [<fc | gige> <port-no>
date [MMDDhhmmCCYY]
exit
fru [restore | save]
help
history
host [ add | mod | rm | add_port | rm_port | add_lunmask | rm_lunmask ]
image {cleanup | list | unpack}
image cleanup
image list
image unpack [<filename>]
initiator [add | rm]
iscsi {discover | login | logout}
logout
passwd
ping
quit
reboot
reset {factory | mappings}
save {capture | logs | traces | portstats}
save capture
save logs
save traces
save portstats <fc | gige> <port-no>
set {alias | chap | chassis | event_notification
fc | features | iscsi | isns
18 Command reference