HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

(none) login:
At the blade management level, quit returns you to the chassis management level. The following
example shows the quit command for the blade:
MPX200 <1> (admin) #> quit
MPX200 #>
reboot
Authority
Admin session
Syntax
reboot
Example
MPX200 <1> (admin) #> reboot
Are you sure you want to reboot the System (y/n): y
System will now be rebooted...
remote mappings
Maps an initiator and target, one of which is located on a remote system (router). After you enter
this command, it prompts you to enter the remote system (router), and then lists the devices (initiators
and targets) located on the remote system. You can select a device from the remote system and
then the local system.
Authority
Admin session
Syntax
remotemap {add | mod | rm}
Keywords
add adds a device mapping, initiator to target, one of which is remote
mod modifies an existing remote device mapping
rm removes a remote device mapping
Examples
The following example shows the remotemap add command:
MPX200 <1> (admin) #> remotemap add
The following wizard will create a mapping a device connected to the
local system and a device connected to the selected remote peer system.
If you wish to terminate this wizard before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index (Symbolic Name/Serial Number)
----- -----------------------------
0 Blade-2(1143F00326)
reboot 35