HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)
set
Configures general router parameters, as well as parameters that are specific to the Fibre Channel,
iSCSI, and management ports.
Authority
Admin session
Syntax
set {alias | chap | chassis | event_notification | fc [<port_num>] |
features | iscsi [<port_num>] | isns | mgmt | ntp | properties | snmp
[trap_destinations [<dest_num>]] | system | vpgroups [vpgroup index]}
Keywords
alias assigns alias name to a presented iSCSI target. (See “set alias” (page 41).)
chap sets the CHAP secrets. (See “set CHAP” (page 42).)
chassis sets the chassis name. (See “set chassis” (page 43).)
event_notification sets the event notification mechanism and destination. (See “set event
notification” (page 43).)
fc [<port_num>]sets the Fibre Channel port parameters. (See “set fc” (page 44).)
features applies license keys to the router. (See “set features” (page 45).)
iscsi {<port_num>} sets the iSCSI port parameters. (See “set iscsi” (page 45).)
isns sets the Internet simple name service (iSNS) parameters. (See “set isns” (page 46).)
mgmt sets the management port parameters. (See “set mgmt” (page 46))
ntp sets the network time protocol (NTP) parameters. (See “set ntp” (page 47).)
properties Configures CLI properties for the blade. (See “set properties” (page 47).)
snmp [trap_destinations {<dest_num>}} sets the SNMP parameters. (See “set snmp ”
(page 48).)
system sets system parameters such as symbolic name and log level. (See “set system” (page
49))
vpgroups [<vpgroup_index>] sets virtual port groups on the blade. (See “set vpgroups”
(page 49).)
set alias
Allows an alias name to be assigned to a presented iSCSI target.
Authority
Admin session
Syntax
set alias
Example
The following example shows the set alias command. The example also shows the results of
this command using the show presented_targets command:
MPX200 <2> (admin) #> set alias
set 41