HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

Syntax
show mgmt
Example
MPX200 <1> (admin) #> show mgmt
Management Port Information
-----------------------------
IPv4 Interface Enabled
IPv4 Mode Dhcp
IPv4 IP Address 172.17.137.129
IPv4 Subnet Mask 255.255.254.0
IPv4 Gateway 172.17.136.1
IPv6 Interface Disabled
Link Status Up
MAC Address 00-c0-dd-0c-8b-e1
show ntp
Displays the router’s NTP configuration.
Authority
None
Syntax
show ntp
Example
MPX200 <1> #> show ntp
NTP Information
-----------------
Mode Disabled
Status Offline
TimeZone Offset (Hours) 0
show performance
Displays the port, read, write, initiator, or target performance in bytes per second.
Authority
None
Syntax
show perf [byte | init_rbyte | init_wbyte | tgt_rbyte | tgt_wbyte]
Keywords
byte displays performance data (bytes per second) for all ports. The show perf byte command
also provides FCIP route performance numbers. If an FCIP route is configured, an additional column
titled FCIPxCx shows the current per-second transmit compression ratio for the specified route.
init_rbyte displays initiator mode read performance.
init_wbyte displays initiator mode write performance.
tgt_rbyte displays target mode read performance.
tgt_wbyte displays target mode write performance.
show ntp 63