HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

ManualsBrandsHP ManualsStorageHP MPX200 10-1GbE Base Multifunction Router

associated with any configured FCIP routes.

Displaying bytes/sec (target mode write)... (Press any key ato

stop display)

GE1 GE2 GE3 GE4 FC1 FC2

---------------------------------------

0 0 0 0 0 0

show port statistics

Displays Fibre Channel or GbE port statistics.

Authority

None

Syntax

show portstats {{fc | gige} <port_no> {hours | mins} <duration>}

Keywords

fc specifies the display of Fibre Channel port statistics.

gige specifies the display of GbE port statistics.

mins specifies that display of statistics by the minute.

hours specifies the display of statistics by the hour.

duration specifies the duration in minutes or hours.

Examples

MPX200 <1> #> show portstats fc 1 mins 10

This will display monitoring statistics of FC Port 1 for last 10 minute(s).

Statistics are displayed in reverse order.

If the router has been rebooted recently, the statistics are displayed

starting from the last reboot.

The statistics contain:

Current Date (once) at start, Time Stamp (TimeStamp),

TX bytes (TxByte), RX bytes (RxByte),

TX frames (TxFrame), RX frames (RxFrame),

FC Invalid CRC Count (CRCErr),

FC Link Failure Error Count (LinkErr),

FC Loss of Sync Error Count (LossSync),

FC Loss of Signal Error Count (LossSgnl),

FC Primitive Sequence Protocol Error Count (PSPErr)

FC Invalid Transmission Word Count (TXWrdErr)

Current Date 12/21/2011

MPX200 <1> #> show portstats fc 1 hours 2

This will display monitoring statistics of FC Port 1 for last 2 hour(s).