HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

Notes
When you set up or start the test, ensure that the Gige Port parameter specifies the same GbE
port number as the WAN link test server and the client.
Examples
The following example shows the wanlinktest setup command where the local IP address is
already configured on the server:
MPX200 <1> (admin) #> wanlinktest setup
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
GE Port (1=GE1, 2=GE2, ...) [GE1 ]
Is Local IP already configured (y=yes, n=no) [y ]
VLAN (0=Enable, 1=Disable) [1=Disable]
Server Port to listen On(3225 FCIP/3260 iSCSI)[ ] 3260
Started iperf Server on port GE1 (socket 3260) sucessfully..!
The following example shows the wanlinktest setup command where the local IP address
requires configuration on the server:
MPX200 <1> (admin) #> wanlinktest setup
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
GE Port (1=GE1, 2=GE2, ...) [GE1 ]
Is Local IP already configured (y=yes, n=no) [y ] n
Local IP Address (IPv4 or IPv6) [0.0.0.0 ] 1.1.1.93
Subnet Mask [0.0.0.0 ] 255.255.255.0
Gateway [0.0.0.0 ]
VLAN (0=Enable, 1=Disable) [1=Disable]
Server Port to listen On(3225 FCIP/3260 iSCSI)[ ] 3260
Started iperf Server on port GE1 (socket 3260) sucessfully..!
The following example shows the wanlinktest start command where the local IP address is
already configured on the client:
MPX200 <2> (admin) #> wanlinktest start
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
GE Port (1=GE1, 2=GE2, ...) [GE1 ] 1
Is Local IP already configured (y=yes, n=no) [y ]
Remote IP Address (IPv4 or IPv6) [0.0.0.0 ] 10.10.10.93
VLAN (0=Enable, 1=Disable) [1=Disable]
Test Duration in Minutes (multiples of 5) [10 ]
Server port to connect to (3225 FCIP/3260 iSCSI) [ ] 3260
Checking whether resources are available to start WAN Link Test
........
WAN Link Test initialization completed successfully
The following example shows the wanlinktest start command where the local IP address
requires configuration on the client:
MPX200 <2> (admin) #> wanlinktest start
WAN link test 83