Manualshelf

HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

ManualsBrandsHP ManualsStorageHP MPX200 10-1GbE Base Multifunction Router
81828384858687888990
4. Click Discovery.
5. Click Add.
6. Type the address of the iSCSI port of the router.
7. Click Advanced.
8. Select Chap Login Information.
9. Type the secret (secret_initiator) you created in Step 2 into Target Secret.
10. Click OK twice.
The initiator completes the discovery.
Discovery session for uni-directional CHAP
Follow this procedure to configure a uni-directional CHAP used during a discovery session:
NOTE: Do not enable CHAP on the ISCSI port.
1. Issue the initiator add command as follows:
a. Add the initiator that is about to perform the discovery.
b. Enable the CHAP for this initiator.
c. Create a secret (for example, secret_initiator).
d. Use the set chap command to update the initiator’s CHAP settings.
2. Go to the MS Initiator.
3. Click Discovery.
4. Click Add.
5. Type the address of the router's iSCSI port.
6. Click Advanced.
7. Select Chap Login Information.
8. In Target Secret, type the secret (secret_initiator) you created in Step 1.
9. Click OK twice.
The initiator completes the discovery.
Normal session for bi-directional CHAP
Follow this procedure to configure a bi-directional CHAP used during a normal session:
1. On the router:
a. Enable CHAP on the presented target to which the initiator will login.
b. Create a secret (for example, secret_target).
c. Issue the set chap command.
2. To add the initiator that is about to do a normal login, issue the initiator add command
as follows:
a. Enable the CHAP for this initiator.
b. Create a secret (for example, secret_initiator).
c. Issue the set chap command to update the CHAP settings of the initiator.
3. Go to the MS Initiator and follow these steps:
a. Click General.
b. Click Secret in the middle of the window.
c. If this is the first time you are setting secrets, reset all the secrets.
d. Type the secret (secret_target) that you created in Step 1.
4. Click Targets and select the target you want to log in to.
5. Click Advanced.
Discovery session for uni-directional CHAP 87