HP MPX200 Mutifunction Router Command Line Interface User Guide (5697-2512, May 2013)

2. Issue the lunmask add command, and then follow the prompts.
MPX200 <1> (admin) #> lunmask add
Index Type Mapped (WWNN,WWPN/iSCSI Name)
----- ---- ------ ----------------------
0 FC No 20:00:00:1b:32:9a:e7:5c,21:00:00:1b:32:9a:e7:5c
Please select an Initiator from the list above ('q' to quit): 0
Index (WWNN,WWPN/iSCSI Name)
----- ----------------------
0 iqn.2001-05.com.equallogic:0-8a0906-7e33e0d06-83c835550264bede-demo1
Please select a Target from the list above ('q' to quit): 0
Index (LUN/VpGroup)
----- -------------
0 0/VPGROUP_1
Please select a LUN to present to the initiator ('q' to quit): 0
Index (IP/WWNN) (MAC/WWPN)
----- ----------- ------------
0 0.0.0.0 00-c0-dd-18-c9-88
1 0.0.0.0 00-c0-dd-18-c9-89
2 192.168.95.20 00-c0-dd-18-c9-8a
3 0.0.0.0 00-c0-dd-18-c9-8b
4 20:00:00:c0:dd:18:c9:88 21:00:00:c0:dd:18:c9:88
5 20:00:00:c0:dd:18:c9:89 21:00:00:c0:dd:18:c9:89
6 20:00:00:c0:dd:18:c9:8a 21:00:00:c0:dd:18:c9:8a
7 20:00:00:c0:dd:18:c9:8b 21:00:00:c0:dd:18:c9:8b
Please select a portal to map the target from the list above ('q' to quit): 5
All attribute values that have been changed will be saved.
In the preceding code, the numbers in the last Index column correspond to the ports shown
in Table 5 (page 99).
Table 5 Post list
PortIndex
GE10
GE21
10GE12
10GE23
FC14
FC25
FCoE1 or FC36
FCoE2 or FC47
Viewing the newly-mapped target zoned to the Fibre Channel host
This procedure identifies the mapping between an iSCSI target and a Fibre Channel or FCoE
presented target, which determines the correct Fibre Channel device to zone with the Fibre Channel
host.
Viewing the newly-mapped target zoned to the Fibre Channel host 99