HP MSA 1040 SMU Reference Guide (762784-001, March 2014)
116 Viewing system status
Controller module: network port properties
When you select a network port, a table shows:
• Health.
OK
Degraded
• Health Reason. If Health is not OK, this field shows the reason for the health state.
• MAC Address.
• Addressing Mode.
• IP Address.
• Gateway.
• Subnet Mask.
Controller module: FC host port properties
When you select an FC host port, a table shows:
• Health.
OK
Degraded
Fault
N/A
• Health Reason. If Health is not OK, this field shows the reason for the health state.
• Status.
• Up: The port is cabled and has an I/O link.
• Warning: Not all of the port’s PHYs are up.
• Not Present: The controller module is not installed or is down.
• Disconnected: Either no I/O link is detected or the port is not cabled.
• Ports. The port ID, which is the controller ID and port number.
• Media.
• FC(L): Fibre Channel-Arbitrated Loop (public or private).
• FC(P): Fibre Channel Point-to-Point.
• FC(-): Fibre Channel disconnected.
• Target ID. The port WWN.
• Configured Speed. Auto, 2Gb, 4Gb, or 8Gb (Gbit/s).
• Actual Speed. Actual link speed in Gbit/s, or blank if not applicable.
• Configured Topology.
• PTP: Fibre Channel Point-to-Point.
• Loop: Fibre Channel-Arbitrated Loop (public or private).
• Primary Loop ID. Primary loop ID, or blank if not applicable.
• SFP Status.
•OK
• Not present: No SFP is inserted in this port.
• Not compatible: The SFP in this port is not qualified for use in this system. When this condition is detected,
event 464 is logged.
• Incorrect protocol: The SFP protocol does not match the port protocol. When this condition is detected, event
464 is logged.
• Part Number. The SFP part number.
• Supported Speeds. The link speeds that the SFP supports, in Gbit/s.