HP MSA 1040 SMU Reference Guide (762784-001, March 2014)
Viewing information about an enclosure 117
Controller module: iSCSI host port properties
When you select an iSCSI host port, a table shows:
• Health.
• Health Reason. If Health is not OK, this field shows the reason for the health state.
• Status.
• Up: The port is cabled and has an I/O link.
• Warning: Not all of the port’s PHYs are up.
• Not Present: The controller module is not installed or is down.
• Disconnected: Either no I/O link is detected or the port is not cabled.
• Ports. The port ID, which is the controller ID and port number.
• Media. iSCSI.
• Target ID. The port IQN.
• Configured Speed. Auto; the link speed is auto-negotiated.
• Actual Speed. Actual link speed in Gbit/s, or blank if not applicable.
• IP Version. The IP version: IPv4 or IPv6.
• MAC. The port’s MAC address.
• IP Address. For IPv4 or IPv6, assigned port IP address.
• Netmask. For IPv4, subnet mask for assigned port IP address.
• Gateway. For IPv4, gateway for assigned port IP address.
• Default Router. For IPv6, default router for assigned port IP address.
• Link-Local Address. For IPv6, the link-local address that is automatically generated from the MAC address and
assigned to the port.
• SFP Status.
•OK
• Not present: No SFP is inserted in this port.
• Not compatible: The SFP in this port is not qualified for use in this system. When this condition is detected,
event 464 is logged.
• Incorrect protocol: The SFP protocol does not match the port protocol. When this condition is detected, event
464 is logged.
• 10G Compliance. The SFP’s 10G compliance code, if supported.
• Cable Length. The link length (in meters) that is supported by the SFP while operating in compliance with
applicable standards for the cable type, or 0 if this information is not provided by the SFP manufacturer.
• Cable Technology. Shows whether the SFP supports active or passive cable technology, or N/A if this information
is not provided by the SFP manufacturer.
• Ethernet Compliance. The SFP’s Ethernet compliance code, if supported.
• Part Number. The SFP part number.
OK
Degraded
Fault
N/A
Unknown