HP MSA Power and Cooling Module Replacement Instructions (481595-003, June 2013)

ManualsBrandsHP ManualsStorageHP MSA 2040 10Gb iSCSI w/6 600GB 6G SAS 10K SFF HDD 3.6TB Bundle/TVlite

HP MSA Power and Cooling

Module Replacement

Instructions

Abstract

This document details procedures for replacing a failed

power and cooling module in an HP enclosure.

Printed in the US

*481595-003*

HP Part Number: 481595-003

Published: June 2013

Edition: 3

About this document

• Illustrations in this document may show modules

or an enclosure that differ slightly from the devices

in your environment.

• The Storage Management Utility (SMU) and the

Command Line Interface (CLI) can be used to

manage the storage enclosure. Tasks in this

document demonstrate using the SMU.

• For the latest product documentation, see the HP

website at http://www.hp.com/support/manuals.

Under the storage banner, navigate to the page

for your storage enclosure.

• Warranties for HP products and services are set

forth in the express warranty statements

accompanying such products and services.

Nothing herein should be construed as constituting

an additional warranty. HP shall not be liable for

technical or editorial errors or omissions contained

herein. To obtain a copy of the warranty for this

product, see the warranty information website:

http://www.hp.com/ go/storagewarranty.

Before you begin

Observe the following:

CAUTION:

• Removing a module from an operational

enclosure significantly changes air flow

within the enclosure. Openings must be

populated for the enclosure to cool

properly. Leave modules in the enclosure

until a replacement is available.

• Parts can be damaged by electrostatic

discharge; use proper anti-static protection.

Keep parts in electrostatic containers until

needed and ensure you are properly

grounded when touching static-sensitive

components.

NOTE: Port-colored (purple) thumbscrews on

modules mean that the module is hot-swappable.

It can be replaced without having to power

down the system.

NOTE: This power and cooling module may

be used as a replacement for a variety of power

and cooling modules, including modules with

an on/off switch.

Page 1

Summary of content (2 pages)

PAGE 1
HP MSA Power and Cooling Module Replacement Instructions About this document Abstract • Illustrations in this document may show modules or an enclosure that differ slightly from the devices in your environment. • The Storage Management Utility (SMU) and the Command Line Interface (CLI) can be used to manage the storage enclosure. Tasks in this document demonstrate using the SMU. • For the latest product documentation, see the HP website at http://www.hp.com/support/manuals.
PAGE 2
The following illustration shows power and cooling module locations: Installing the replacement module 1. 3. With the latch in the open position, slide the module into the enclosure as far as it will go (1). Rotate the latch upward to engage the module internal connector (2). Turn the thumbscrews finger-tight (3). 4. 5. Reconnect the power cord. Turn on the module power switch (if present). 2. 1. Power and cooling mod 1 2.