MSA 2040 SMU Reference Guide

108 Viewing system status
Schedule properties
If any schedules exist for this volume, when you select the Schedules component, the Schedules table shows each
schedule’s name, specification, status, next run time, task type, task status, and task state. For the selected schedule,
two tables appear.
The Schedule Details table shows:
• Schedule Name. Schedule name.
• Schedule Specification. The schedule’s start time and recurrence or constraint settings.
• Status.
• Uninitialized: Schedule is not yet ready to run.
• Ready: Schedule is ready to run.
• Suspended: Schedule is suspended.
• Expired: Schedule has expired.
• Invalid: Schedule is invalid.
• Next Time. The next time the associated task will run.
The Task Details table shows different properties depending on the task type. Properties shown for all task types are:
• Task Name. Task name.
• Task Type. ReplicateVolume, ResetSnapshot, TakeSnapshot, or VolumeCopy.
• Status.
• Uninitialized: Task is not yet ready to run.
• Ready: Task is ready to run.
• Active: Task is running.
• Error: Task has an error.
• Invalid: Task is invalid.
• Task State. Current step of task processing. Steps vary by task type.
• Source Volume. Name of the volume to snap, copy, or replicate.
• Source Volume Serial. Source volume serial number.
• Destination Vdisk. Name of the destination vdisk for a volume copy.
• Destination Vdisk Serial. Destination vdisk serial number.
• Prefix. Label that identifies snapshots, volume copies, or replication images created by this task.
• Count. Number of snapshots to retain with this prefix. When a new snapshot exceeds this limit, the oldest
snapshot with the same prefix is deleted.
• Last Created. Name of the last snapshot, volume copy, or replication image created by the task.
• Last Used Snapshot. For a task whose replication mode is last-snapshot, the name of the last snapshot used for
replication.
• Snapshot Name. Name of the snapshot to reset.
• Snapshot Serial. Snapshot serial number.
• Mode. Replication mode:
• new-snapshot: Replicate a new snapshot of the primary volume.
• last-snapshot: Replicate the most recent existing snapshot of the primary volume.
For a TakeSnapshot task, the Retained Set table shows the name and serial number of each snapshot that the task has
taken and is retaining.