MSA 2040 SMU Reference Guide

Viewing information about an enclosure 119
Not Present: The controller module is not installed or is down.
Disconnected: Either no I/O link is detected or the port is not cabled.
Ports. The port ID, which is the controller ID and port number.
Media.
FC(L): Fibre Channel-Arbitrated Loop (public or private).
FC(P): Fibre Channel Point-to-Point.
FC(-): Fibre Channel disconnected.
Target ID. The port WWN.
Configured Speed. Auto, 4Gb, 8Gb, or 16Gb (Gbit/s).
Actual Speed. Actual link speed in Gbit/s, or blank if not applicable.
Configured Topology.
PTP: Fibre Channel Point-to-Point.
Loop: Fibre Channel-Arbitrated Loop (public or private).
Primary Loop ID. Primary loop ID, or blank if not applicable.
SFP Status.
•OK
Not present: No SFP is inserted in this port.
Not compatible: The SFP in this port is not qualified for use in this system. When this condition is detected,
event 464 is logged.
Incorrect protocol: The SFP protocol does not match the port protocol. When this condition is detected, event
464 is logged.
Part Number. The SFP part number.
Supported Speeds. The link speeds that the SFP supports, in Gbit/s.
Controller module: iSCSI host port properties
When you select an iSCSI host port, a table shows:
Health.
Health Reason. If Health is not OK, this field shows the reason for the health state.
Status.
Up: The port is cabled and has an I/O link.
Warning: Not all of the port’s PHYs are up.
Not Present: The controller module is not installed or is down.
Disconnected: Either no I/O link is detected or the port is not cabled.
Ports. The port ID, which is the controller ID and port number.
Media. iSCSI.
Target ID. The port IQN.
Configured Speed. Auto; the link speed is auto-negotiated.
Actual Speed. Actual link speed in Gbit/s, or blank if not applicable.
IP Version. The IP version: IPv4 or IPv6.
MAC. The port’s MAC address.
IP Address. For IPv4 or IPv6, assigned port IP address.
Netmask. For IPv4, subnet mask for assigned port IP address.
OK
Degraded
Fault
N/A
Unknown