HP StorageWorks 2312/2324 Modular Smart Array controller installation instructions (508933-001, January 2009)

HP StorageWorks 2312/2324
Modular Smart A
rray controller
installation instructions
© Copyright 1999, 2008 Hewlett-Packard D evelopment Company,
L.P.
First edition: November, 2008
The info
rmationinthisdocumentissubjecttochangewithout
notice.
Printed in the China
www.hp.com
50
8933-001
About this document
This document describes procedures for installing a controller into a n
HP Storage Works 2312/2324 Modular Smart Array.
Before you begin
CAUTION:
When upgrading an existing operational system with a second
optional controller, removing the air management blank impacts
the airflow and
cooling ability of the device. To avoid possible
overheating, insert the controller as quickly as possible. If the
internal temperature exceeds acceptable limits, the enclosure may
overheat and automatically shut down or restart.
CAUTION:
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection.
• Keep the replacement component in the ESD bag until needed.
• Wear an ESD wrist strap grounded to an unpainted surface
of the chassis.
• If an ESD wrist strap is unavailable, touch an unpainted surface
of the chassis befor e handling the component .
• Never touch connector pins.
Installing a controller (single or dual) for
the first time
Remove the air management blank(s)
NOTE:
For clarity, only relevant details are shown in these illustrations.
1. Turn the thumbscrews until the screws disengage from the blank.
1—Lat
ch
2—Thu
mbscrew
2. Press both latches downward.
Page 1