HP StorageWorks MSL6000 series tape library user guide (231910-009, February 2008)

MSL6000 series tape library user guide 39
3 Library Configuration
This chapter explains how to configure an HP StorageWorks MSL Series tape library for normal
operation. Sections in this chapter include:
• Changing Default Configuration Settings, page 39
• Setting a SCSI ID, page 39
• Setting Up a Reserved Slot, page 41
• Configuring the Network Settings, page 47
Changing Default Configuration Settings
For most applications, you do not have to change the default settings; however, if you do need to
change a configuration setting, use the procedures provided in the following sections. If you are
uncertain whether you need to change a setting, contact your authorized service provider.
Configuration settings that might need to be changed include:
• Setting a SCSI ID, page 39
• Setting Up a Reserved Slot, page 41t
• Configuring the Network Settings, page 47
Change configuration settings using the graphical user interface (GUI) touch screen. For a complete
description of how the GUI touch screen works, see Chapter 4, ”Operation” on page 49.
Setting a SCSI ID
Each tape drive installed in the library requires a unique SCSI ID. The information provided in this
section shows you how to set a SCSI ID.
To set a SCSI ID:
1. Turn the library on and wait until the Power-On Self Test (POST) concludes and the Status
screen is displayed.
2. Select the Menu option.
3. Select SCSI in the Edit Options area to display the following screen.