HP StorageWorks MSL8048 and MSL8096 Tape Library firmware release notes (AK382-96016, March 2010)

Table Of Contents

HP StorageWorks MSL8048 and

MSL8096 Tape Library firmware release

notes

Firmware version 9.90

Part number: AK382-96016

First edition: March 22, 2010

PAGE 1
HP StorageWorks MSL8048 and MSL8096 Tape Library firmware release notes Firmware version 9.
PAGE 3
Version: 9.90 Description This release includes updated firmware for the HP StorageWorks MSL8048 and MSL8096 Tape Libraries. The firmware can be updated through any of the following methods: • Remote management interface (RMI). • Operator control panel (OCP) using a USB flash drive. • HP Library and Tape Tools (L&TT). Library firmware version 9.90 Compatible robotics firmware version Update recommendation Supersedes 3.00e Recommended All previous versions of Library firmware.
PAGE 4
Fixes • Fixed a case where the firmware failed to set the SEQ bit on the MODE Sense Page 0x20 after an library mode configuration change from Automatic mode or Random mode to Sequential mode. • Fixed a case where the RMI address was not updated on Inquiry Page 85h until after the Library was rebooted. Compatibility note When using firmware version 9.
PAGE 5
. On the Update Firmware tab, select the box next to each device for which you want to update firmware. If firmware is currently available for that device, it is shown in Firmware File in the File Selection section of the screen. 6. Click Start Update at the bottom of the screen to begin the update. Determining current version To find the version of firmware installed on the Library, see the RMI Support: Firmware screen or the OCP Info > Library Identity option.
PAGE 6