MSL5000 and 6000 Series Tape Libraries User Guide

Troubleshooting
151HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
3051 No Cartridges In Library
(No cartridge available for diag to run.)
■ Press the Enter button to clear the
message.
■ Insert cartridge.
■ Invalid user initiated operation. Set
parameters correctly and try again.
3052 Too Many Cartridges
(Unable to run cartridge or drive cycle
because loader is full with cartridges.)
■ Press the Enter button to clear the
message.
■ Remove a tape from the library.
■ Invalid user initiated operation. Set
parameters correctly and try again.
3054 Need 1 Drive Minimum
(No available drive to run diag.)
■ Install or activate a drive.
■ Press the Enter button to clear the
message.
■ Invalid user initiated operation. Set
parameters correctly and try again.
3057 Invalid Magazine Type
(Unsupported magazine type detected.)
■ Upgrade firmware if a newer revision
exists.
■ Press the Enter button to clear the
message.
■ Invalid user initiated operation. Set
parameters correctly and try again.
3058 Magazine Type Change Not
Handled
(Unsupported magazine type detected.)
■ Upgrade firmware if a newer revision
exists.
■ Press the Enter button to clear the
message.
■ Invalid user initiated operation. Set
parameters correctly and try again.
3059 Drive Type Not Supported
(Unsupported magazine type detected.)
■ Upgrade firmware if a newer revision
exists.
■ Press the Enter button to clear the
message.
■ Invalid user initiated operation. Set
parameters correctly and try again.
Table 11: Fault Symptom Codes (Continued)
FSC Message ERP