MSL5000 and 6000 Series Tape Libraries User Guide
Troubleshooting
163HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
7012 Drive is Active failed
(The drive task indicates that a request to
determine if a drive is executing a host
command failed. Reason unknown.)
■ Press the Enter button clear the message.
■ Cycle power to the library or reboot using
the GUI touch screen.
■ Ensure the drive shows good status
through the drive status window.
7013 Control Com Unidentified
(During a hot swap, a command response
from the control task could not be
associated with any outstanding
command.)
■ Press the Enter button clear the message.
■ Cycle power to the library or reboot using
the GUI touch screen.
■ Ensure the drive shows good status
through the drive status window.
7014 Drive status update failed
(The drive task indicates that a request to
determine the current state of a drive failed.
Reason unknown.)
■ Press the Enter button clear the message.
■ Cycle power to the library or reboot using
the GUI touch screen.
■ Ensure the drive shows good status
through the drive status window.
7015 Loader command execution
failed
(The loader task indicates that a command
has failed to complete successfully.)
■ Press the Enter button clear the message.
■ Cycle power to the library or reboot using
the GUI touch screen.
7016 Sequential command execution
failed
(The sequential task indicates that a
command has failed to complete
successfully.)
■ Press the Enter button clear the message.
■ Cycle power to the library or reboot using
the GUI touch screen.
7017 Destination Xchg for msg. was
Null
(Attempted to send a message to a task,
but the argument exchange pointer was
NULL.)
■ Press the Enter button clear the message.
■ Cycle power to the library or reboot using
the GUI touch screen.
7018 Bad src mod in peg msg
(A message was received from a remote
module, but the module number was out of
range.)
■ Press the Enter button clear the message.
■ Cycle power to the library or reboot using
the GUI touch screen.
7019 Peg message wrapping a Null
msg. ptr.
(A peg message has a pointer to NULL.)
■ Press the Enter button clear the message.
■ Cycle power to the router.
■ Cycle power to all libraries in a stack, or
reboot using the GUI touch screen.
Table 11: Fault Symptom Codes (Continued)
FSC Message ERP