MSL5000 and 6000 Series Tape Libraries User Guide

Library Configuration
55HP StorageWorks MSL5000 and MSL6000 Series Tape Libraries User Guide
Setting a SCSI ID
Each tape drive installed in the library requires a unique SCSI ID. The information
provided in this section shows you how to set a SCSI ID.
To set a SCSI ID:
1. Turn the library on and wait until the Power-On Self Test (POST) concludes
and the Status screen is displayed.
2. Select the Menu option.
3. If necessary, enter the appropriate password. See the section on “Front Panel
and Media Security Locks” on page 71 for instructions on how to set
passwords.
4. Select SCSI in the Edit Options area to display the following screen.
Figure 19: SCSI option selection screen (two-drive model shown)
Note: You can move to the next sequential SCSI options screen by touching the ▼.