Network Storage Router e1200-160 - User Guide
Serial/Telnet User Interface
107Network Storage Router e1200-160
Note: This value should be set to no less than 250ms, according to the SCSI standard
for Reset-to-Selection Time. HP recommends setting the value to at least 30 seconds to
ensure all SCSI devices complete their individual POST.
■ 5) Set SCSI Termination Mode enables or disables the SCSI termination
mode.
■ 6) Edit SCSI Target Override Settings changes the SCSI Target overrides.
SCSI Parameter Override Configuration Menu options:
— 1) Toggle CDB Length Override: enabled or disabled.
If enabled, the following configuration options are displayed:
CDB Group 6 Length Default (default = 0) can be set to 0, 6, 10, or 12.
CDB Group 7 Length Default (default = 0) can be set to 0, 6, 10, or 12.
— 2) Toggle Wide Negotiation: enabled or disabled.
— 3) Toggle Synchronous Negotiation: enabled or disabled.
If enabled, the following configuration options are displayed:
Synchronous Period (default = 40) is the maximum number of seconds
allowed for negotiation.
Synchronous Offset (default =16) is the maximum variation in transfer
rate that can be negotiated in MB/s.
— 4) Toggle Synchronous Parameter Override: enabled or disabled.
■ 7) Enable/Disable Buffered Tape Writes (default: Enabled) enables or
disables Buffered Tape Writes.
Buffered Tape Writes return status on consecutive write commands before the
tape device receives data, to enhance performance.
■ 8) Change Default Map Value sets the default map to use for the bus.
Mapping modes can be Auto-Assigned (default), Indexed, or SCC.
For more information about addressing methods, see Appendix C,
"Addressing Methods and Table Structures."
■ X) Return to previous menu returns to previous menu.
■ Command <Enter> scrolls to the next SCSI bus.