R2511-HP MSR Router Series ACL and QoS Command Reference(V5)

138
# Display the P2P traffic statistics on Ethernet 1/1.
<Sysname> display dar protocol-statistic p2p interface ethernet 1/1
Interface: Ethernet1/1
Protocol In/Out Packet Count Byte Count Bit Rate Max Bit Rate
in 5 min in 5 min
(bps) (bps)
MSN IN 0 0 0 0
OUT 0 0 0 0
Yahoo Message IN 0 0 0 0
OUT 0 0 0 0
Total IN 0 0 0 0
OUT 3 126 0 0
Table 41 Command output
Field Descri
p
tion
Protocol Protocol name.
In/Out Direction of packets (inbound/outbound).
Packet Count Number of packets.
Byte Count Number of bytes.
Bit Rate in 5 min(bps) Average bit rate in 5 minutes (in bps).
Max Bit Rate in 5 min(bps) Maximum bit rate in 5 minutes (in bps).
if-match protocol
Use if-match protocol to define a protocol-based match criterion.
Use undo if-match protocol to delete the match criterion.
Syntax
if-match [ not ] protocol protocol-name
undo if-match [ not ] protocol protocol-name
Default
No protocol-based match criterion is configured.
Views
Class view
Default command level
2: System level
Parameters
not: Specifies to match packets not conforming to the specified criterion.
protocol-name: Protocol name to be matched, which can be one of the following names: bgp, cifs, citrix,
cuseeme, dhcp, dns, egp, eigrp, exchange, fasttrack, finger, ftp, gnutella, gopher, gre, h323, icmp,
igmp, imap, ip, ipinip, ipsec, ipv6, irc, kerberos, l2tp, ldap, mgcp, napster, netbios, netshow, nfs, nntp,
notes, novadign, ntp, pcanywhere, pop3, pptp, printer, rcmd, rip, rsvp, rtcp, rtsp, secure-ftp,
secure-http, secure-imap, secure-irc, sec
ure-ldap, secure-nntp, secure-pop3, secure-telnet, sip, skinny,