R2511-HP MSR Router Series ACL and QoS Configuration Guide(V5)

9
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an IPv6 advanced
ACL and enter its view.
acl ipv6 number acl6-number [ name
acl6-name ] [ match-order { auto |
config } ]
By default, no ACL exists.
IPv6 advanced ACLs are
numbered in the range of 3000
to 3999.
You can use the acl ipv6 name
acl6-name command to enter the
view of a named ACL.
3. Configure a description for
the IPv6 advanced ACL.
description text
Optional.
By default, an IPv6 advanced
ACL has no ACL description.
4. Set the rule numbering
step.
step step-value
Optional.
The default setting is 5.
5. Create or edit a rule.
rule [ rule-id ] { deny | permit } protocol
[ { { ack ack-value | fin fin-value | psh
psh-value | rst rst-value | syn syn-value
| urg urg-value } * | established } |
counting | destination { dest-address
dest-prefix | dest-address/dest-prefix |
any } | destination-port operator port1
[ port2 ] | dscp dscp | flow-label
flow-label-value | fragment |
icmp6-type { icmp6-type icmp6-code |
icmp6-message } | logging | routing
[ type routing-type ] | source
{ source-address source-prefix |
source-address/source-prefix | any } |
source-port operator port1 [ port2
] |
time-range time-range-name |
vpn-instance vpn-instance-name ] *
By default IPv6 advanced ACL
does not include any rule.
Support for the counting keyword
depends on the device model.
The logging keyword takes effect
only when the module using the
ACL supports logging.
6. Add or edit a rule
comment.
rule rule-id comment text
Optional.
By default, no rule comments are
configured.
7. Add or edit a rule range
remark.
rule [ rule-id ] remark text
Optional.
By default, no rule range remarks
are configured.
Configuring an Ethernet frame header ACL
Ethernet frame header ACLs, also called "Layer 2 ACLs," match packets based on Layer 2 protocol
header fields, such as source MAC address, destination MAC address, 802.1p priority (VLAN priority),
and link layer protocol type.
To configure an Ethernet frame header ACL:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A