R2511-HP MSR Router Series ACL and QoS Configuration Guide(V5)

64
2. Enter interface view or PVC
view.
• Enter interface view:
interface interface-type
interface-number
• Enter PVC view:
a. interface atm
interface-number
b. pvc vpi/vci
N/A
3. Set the maximum reserved
bandwidth as a percentage of
available bandwidth.
qos reserved-bandwidth pct
percent
The default setting is 80.
Displaying and maintaining CBQ
Task Command Remarks
Display class
configuration
information.
display traffic classifier { system-defined | user-defined }
[ classifier-name ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view.
Display traffic behavior
configuration
information.
display traffic behavior { system-defined | user-defined }
[ behavior-name ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view.
Display QoS policy
configuration
information.
display qos policy { system-defined | user-defined }
[ policy-name [ classifier classifier-name ] ] [ | { begin |
exclude | include } regular-expression ]
Available in any
view.
Display interface/PVC
QoS policy
configuration
information.
display qos policy interface [ interface-type
interface-number ] [ inbound | outbound ] [ pvc { pvc-name
[ vpi/vci ] | vpi/vci } ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view.
Display interface/PVC
CBQ configuration
information.
display qos cbq interface [ interface-type interface-number
[ pvc { pvc-name [ vpi/vci ] | vpi/vci } ] ] [ | { begin |
exclude | include } regular-expression ]
Available in any
view.
CBQ configuration example
Network requirements
As shown in Figure 21, configure a QoS policy to meet the following requirements:
• Traffic from Router C is classified into three classes based on DSCP values. Perform AF for traffic with
the DSCP values being AF11 and AF21, and set a minimum guaranteed bandwidth percentage of
5% for the traffic.
• Perform EF for traffic with the DSCP value being EF and set the maximum bandwidth percentage for
the traffic to 30%.
Before performing the configuration, make sure that:
• The route from Router C to Router D through Router A and Router B is reachable.
• The DSCP fields have been set for the traffic before the traffic enters Router A.