R2511-HP MSR Router Series Fundamentals Command Reference(V5)

96
Syntax
nms { primary | secondary } monitor-interface interface-type interface-number
undo nms { primary | secondary } monitor-interface
Default
A network management system (NMS) does not monitor any interface on the device.
Views
System view
Default command level
3: Manage level
Parameters
primary: Specifies the primary monitored interface.
secondary: Specifies the secondary monitored interface.
interface-type interface-number: Type and number of the interface to be monitored.
Usage guidelines
If you configure only the primary monitored interface or the secondary monitored interface, the device
monitors the IP address of the configured interface. If the interface gets or changes its IP address when
the interface status is up, the device sends traps to the NMS to inform it of the available IP address.
If you configure both the primary and secondary monitored interfaces, the device monitors the primary
one first.
The following matrix shows the command and router compatibility:
Command MSR900 MSR93
X
MSR20-1
X
MSR20 MSR30 MSR50 MSR1000
nms
monitor-interface
Yes Yes Yes No No No Yes
Examples
# Configure Ethernet 1/1 as the primary monitored interface
<Sysname> system-view
[Sysname] nms primary monitor-interface ethernet 1/1
password-recovery enable
Use password-recovery enable to enable password recovery capability.
Use undo password-recovery enable to disable password recovery capability.
Syntax
password-recovery enable
undo password-recovery enable
Default
Password recovery capability is enabled.