R2511-HP MSR Router Series Fundamentals Command Reference(V5)

36
Default command level
3: Manage level
Parameters
port-number: Port number of the HTTP service, in the range of 1 to 65535.
Usage guidelines
This command is not available in FIPS mode.
Verify that the port number is not used by another service, because this command does not check for
conflicts with configured port numbers.
Examples
# Configure the port number of the HTTP service as 8080.
<Sysname> system-view
[Sysname] ip http port 8080
Related commands
display ip http
ip https acl
Use ip https acl to associate the HTTPS service with an ACL.
Use undo ip https acl to remove the association.
Syntax
For devices supporting both WLAN ACL and basic ACL:
ip https acl acl-number
undo ip https acl acl-number
For devices supporting basic ACL only:
ip https acl acl-number
undo ip https acl acl-number
Default
The HTTPS service is not associated with any ACL.
Views
System view
Default command level
3: Manage level
Parameters
acl-number: ACL number. The value ranges are as follows:
• WLAN ACL—100 to 199. WLAN ACLs are not supported on MSR50 routers that use MPU-G2 cards
and MSR93X(except JG512A, JG519A and JG597A) routers.
• Basic IPv4 ACL—2000 to 2999.