R2511-HP MSR Router Series Fundamentals Command Reference(V5)

58
Parameters
level: Specifies a user privilege level in the range of 0 to 3.
Usage guidelines
This command is not available in FIPS mode. In FIPS mode, the authentication mode can only be scheme.
User privilege levels include visit, monitor, system, and manage, represented by the number 0, 1, 2 and
3 respectively. You can change the user privilege level when necessary.
Examples
# Set the command level for users logging in through VTY 0 to 0.
<Sysname> system-view
[Sysname] user-interface vty 0
[Sysname-ui-vty0] user privilege level 0
After you Telnet to the device through VTY 0, the terminal only displays commands of level 0 in the help
information:
<Sysname> ?
User view commands:
cluster Run cluster command
display Display current system information
ping Ping function
quit Exit from current command view
rsh Establish one RSH connection
ssh2 Establish a secure shell client connection
super Set the current user priority level
telnet Establish one TELNET connection
tracert Trace route function
user-interface
Use user-interface to enter user interface view.
Syntax
user-interface { first-num1 [ last-num1 ] | { aux | console | tty | vty } first-num2 [ last-num2 ] }
Views
System view
Default command level
2: System level
Parameters
first-num1: Specifies the absolute number of the first user interface. The value range typically starts from
0.
last-num1: Specifies the absolute number of the last user interface. The value range typically starts from
0, and last-num1 cannot be smaller than first-num1.
aux: Specifies the AUX user interface.
console: Specifies the console user interface.
tty: Specifies the TTY user interface.