R2511-HP MSR Router Series Interface Command Reference(V5)

181
ft1 timeslot-list
Use ft1 timeslot-list to bundle timeslots on a T1-F interface.
Use undo ft1 timeslot-list to restore the default.
Syntax
ft1 timeslot-list list [ speed { 56k | 64k } ]
undo ft1 timeslot-list
Default
All the timeslots on the T1-F interface are bundled to form a 1536 kbps interface.
Views
T1-F interface view
Default command level
2: System level
Parameters
list: Specifies timeslots to be bundled. They are numbered 1 through 24. You can specify a single timeslot
by specifying its number, a range of timeslots by specifying a range in the form of number1-number2, or
several discrete timeslots by specifying number1, number2-number3.
speed { 56k | 64k }: Time slot bundling speed in kbps. If 56k applies, timeslots are bundled into an N
× 56 kbps bundle. If 64k (the default) applies, timeslots are bundled into an N × 64 kbps bundle.
Usage guidelines
Timeslot bundling results in interface rate change. For example, after you bundle timeslots 1 through 10
on the interface, the interface rate becomes 10 × 64 kbps or 10 × 56 kbps.
Only one channel set can be created on a T1-F interface, and this channel set is associated with the
current synchronous serial interface. On a CT1/PRI interface, however, you can create multiple channel
sets; for each of them, the system automatically creates a synchronous serial interface.
Examples
# Bundle timeslots 1, 2, 5, 10 through 15, and 18 on T1-F interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] ft1 timeslot-list 1,2,5,10-15,18
Basic CE3 interface configuration commands
bert (CE3 interface)
Use bert to enable BERT test.
Use undo bert to disable BERT test.
Syntax
bert pattern { 2^7 | 2^11 | 2^15 | qrss } time number [ unframed ]
undo bert