R2511-HP MSR Router Series Interface Command Reference(V5)

273
Views
ATM (G.SHDSL) interface view
Default command level
2: System level
Usage guidelines
With line probing enabled, the system performs the line probing function to find the highest possible data
transmission rate during line activation. With line probing disabled, the system chooses the highest data
transmission rate from the data transmission rates supported by both the CPE and CO. In the latter case,
because the line rate adaptation process is skipped, the time for activating the SHDSL lines is reduced.
Examples
# Disable SHDSL line probing on interface ATM 1/0.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] undo shdsl line-probing enable
shdsl mode
Use shdsl mode to set the operating mode for a G.SHDSL interface.
Use undo shdsl mode to restore the default.
Syntax
shdsl mode { co | cpe }
undo shdsl mode
Default
A G.SHDSL interface operates in CPE mode.
Views
ATM (G.SHDSL) interface view
Default command level
2: System level
Parameters
co: Specifies the central office (CO) mode.
cpe: Specifies the Customer Premises Equipment (CPE) mode.
Usage guidelines
For a back-to-back connection, configure one end to CO mode and the other end to CPE mode.
Examples
# Set the operating mode of interface ATM 1/0 to CO.
<Sysname> system-view
[Sysname] interface atm 1/0
[Sysname-Atm1/0] shdsl mode co