R2511-HP MSR Router Series Interface Command Reference(V5)

286
Field Descri
p
tion
Output queue : (Urgent queue :
Size/Length/Discards)
Urgent queue: the number of packets in the queue, the
queue length, the number of packets dropped in the
queue.
Output queue : (Protocol queue :
Size/Length/Discards)
Protocol queue: the number of packets in the queue,
the queue length, the number of packets dropped in
the queue.
Output queue : (FIFO queuing :
Size/Length/Discards)
FIFO queue: the number of packets in the queue, the
queue length, the number of packets dropped in the
queue.
Last clearing of counters Time when the counters were last cleared.
Last 300 seconds input rate 0 bytes/sec, 0 bits/sec, 0
packets/sec
Input rate in Bps, bps, and pps in the last 300
seconds.
Last 300 seconds output rate 0 bytes/sec, 0 bits/sec,
0 packets/sec
Output rate in Bps, bps, and pps in the last 300
seconds.
Input: 31 packets, 484 bytes Count of input traffic in both packets and bytes.
Output:29 packets, 460 bytes Count of output traffic in both packets and bytes.
The brief information of interface(s) under route mode Brief information about Layer 3 interfaces.
Link: ADM - administratively down; Stby - standby
Link status:
• ADM—The interface has been administratively
shut down. To recover its physical state, perform
the undo shutdown command.
• Stby—The interface is operating as a backup
interface. To see the primary interface, use the
display standby state command in High
Availability Command Reference.
Protocol: (s) - spoofing
If the network layer protocol state of an interface is
shown as UP, but its link is an on-demand link or not
present at all, its protocol attribute includes the
spoofing flag (an s in parentheses).
Interface Abbreviated interface name.
Link
Physical link state of the interface:
• UP—The link is up.
• ADM—The link has been administratively shut
down. To recover its physical state, use the undo
shutdown command.
Protocol
Protocol connection state of the interface:
• UP.
• DOWN.
• UP(s).
Main IP Main IP address of the interface.
Description Description of the interface.
Cause
Cause of a DOWN physical link. If the port was shut
down with the shutdown command, this field displays
Administratively. To restore the physical state of the
interface, use the undo shutdown command.