R2511-HP MSR Router Series Interface Command Reference(V5)

24
speed
Use speed to set the speed of an Ethernet interface.
Use undo speed to restore the default.
Syntax
speed { 10 | 100 | 1000 | auto }
undo speed
Views
Ethernet interface view
Default
The default value of this command is auto.
Default command level
2: System level
Parameters
10: Sets the interface speed to 10 Mbps. This keyword is not available on fiber combo ports
100: Sets the interface speed to 100 Mbps. This keyword is not available on fiber combo ports.
1000: Sets the interface speed to 1000 Mbps. Support for this keyword depends on your interface card
model.
auto: Enables the interface to negotiate a speed with its peer.
Usage guidelines
For an Ethernet copper port, use the speed command to set its speed to match the speed of the peer
interface.
For a fiber port, use the speed command to set its speed to match the rate of a pluggable transceiver.
Examples
# Configure Ethernet 1/1 to operate at 100 Mbps.
<Sysname> system-view
[Sysname] interface ethernet 1/1
[Sysname-Ethernet1/1] speed 100
Related commands
speed auto
Layer 2 Ethernet interface configuration commands
broadcast-suppression
Use broadcast-suppression to set the broadcast suppression threshold on an Ethernet interface, a
subinterface, or a group of Ethernet interfaces.
Use undo broadcast-suppression to restore the default broadcast suppression threshold.